The Fusion APT system provides therapeutic alternating pressure to aid in pressure redistribution. The pump uses a 2-in-1 alternating cycle every 10 minutes and is quiet enough to help with restorative sleep. The Fusion APT is an ideal mattress system for the prevention and treatment of stage I-II pressure injuries.
With 3.5” wide transfer edges, the Fusion APT enables safer transfers on and off the surface and reduces the risks of falls.
The pump controls offer eight adjustable levels of comfort depending on the user’s therapy requirements. It also includes a low-pressure alarm which sounds when the air pressure of the mattress is lower than the default setup.
In the event of a power outage the Fusion APT remains inflated for up to 24 hours.
The transfer edges as well as base unit of this mattress system are all coated in a fluid resistant nylon fabric. This allows for easy clean up and eliminates risk of contamination to any foam components.
18 28”x 5” Denier Covered Polyurethane air cells set inside a foam crib. The foam crib creates the 3.5” transfer borders on each side of the air cells, as well as 1” foam border on the top and bottom of the cells. The entire foam crib is covered in a disinfect able nylon fabric.
Mattress has 5” air bladder and 3” wide transfer edges
2-in-1 alternating 10-minute cycles
Mattress stays inflated in a power outage up to 24 hours
Low pressure alarm is triggered when the air pressure is lower than the default setup
System is easy to clean
Recovery 5 quilted top cover is anti-microbial, fluid resistant and breathable
Nylon bottom cover is low slip to keep the mattress in place on the bed